Topics created by DrWino

maybe M5Stack Pin interface broken, you can program the GPIO, GPIO 26 to High level, then test it doesn normal.
if have any question, pls contact our store. thanks

If you build apps with M5ez, Over The Air updates via https are built-in. Check the OTA https example to see how it works.

Try using this code from this link to add to your M5stack Digital Clock example.

https://github.com/adafruit/RTClib/blob/master/examples/ds3231/ds3231.ino

you need to install the RTClib master library to make it work.

MKII (PSRAM) camera
Standby = 0.1A
connected = 0.14A 00592mah
5.18V
Running a lot cooler then the MKI

I don't have anything else to test so that's all I can give.
Measurements taken with a Keweisi branded usb test meter.

Hi, I had the same problem as you, my M5stack did not connect or crash if you did it by force, for cons I solved my problem by installing a new firmware and changing USB port, I was on a HUB and now I'm using a USB port on my PC

Link of the firmware : https://github.com/botofancalin/M5Stack-MultiApp-Advanced

Hello all

or try this.

Thanks
Felix

Fully agree on this one.
Having access to the bus signal would be a minimum.

@drwino I've not seen any designs available in STEP format. DXF and DWG formats are available via the link below, along with some 3D design examples.

Note Zazardev's Proto design - he managed to alter the original Proto STL at least a little as he filled in the holes in the frame.

https://github.com/PartsandCircuits/M5Stack-3DPrintFiles

Here is the solution. https://github.com/Bodmer/TFT_eSPI/tree/master/examples/Sprite/Sprite_scroll

Thanks to @Calin

@drwino
:-)
Good luck.