Posts made by tomorrow56

I use the Web IDE version.

Hello,

Still I cannot switch UIFlow to 1.4.0...
I can only switch to 1.4.0-bata or 1.3.2.

And even if I open it on the 1.4.0-beta site, I can't save this sketch.
Save menu is not working, the Run button does not respond.

Thank you and best regards,

Hello,

I cannot switch the version of UIFlow to 1.3.5...
"1.3.5" means the firmware version?

Hello,

I am trying to use Finger Unit with UIFlow 1.3.2.

When I place "read user with id access" block(as below), I cannot save the sketch.

Please let me know how to solve this problem.....

Regards,

Hello,

Thanks... I will try to use OLED by Arduino IDE.

Can I use M5Stick's OLED screen with UI.Flow?

I set port A for CatEar, it is OK!!

I'd like to set CatEar with UIFlow of M5Stick, how do I set Port?

Is there a way to use the default FW somewhere?

Hello,

I am trying the example of "MPU 9250 Basic AHRS.ino" with M5GO, but the detection value does not change even if moving the unit.

Log of Serial Monitor is below,

ax = 78.12 ay = -1905.15 az = 1003.85 mg
gx = 9.77 gy = -238.14 gz = 125.48 deg/s
mx = -470 my = -120 mz = -125 mG
q0 = -0.74 qx = 0.62 qy = -0.05 qz = -0.25
Yaw, Pitch, Roll: 10.93, 22.77, -75.66
rate = 9097.85 Hz

ax = 78.12 ay = -1905.15 az = 1003.85 mg
gx = 9.77 gy = -238.14 gz = 125.48 deg/s
mx = -470 my = -120 mz = -125 mG
q0 = -0.63 qx = 0.48 qy = 0.21 qz = -0.57
Yaw, Pitch, Roll: 65.29, 16.76, -61.87
rate = 9099.84 Hz

ax = 78.12 ay = -1905.15 az = 1003.85 mg
gx = 9.77 gy = -238.14 gz = 125.48 deg/s
mx = -470 my = -120 mz = -125 mG
q0 = -0.46 qx = 0.28 qy = 0.40 qz = -0.74
Yaw, Pitch, Roll: 105.90, 2.25, -58.74
rate = 9121.63 Hz
...

I want to know if this condition is normal.

Regards,