I use the Web IDE version.
Still I cannot switch UIFlow to 1.4.0...
I can only switch to 1.4.0-bata or 1.3.2.
And even if I open it on the 1.4.0-beta site, I can't save this sketch.
Save menu is not working, the Run button does not respond.
Thank you and best regards,
I cannot switch the version of UIFlow to 1.3.5...
"1.3.5" means the firmware version?
I am trying to use Finger Unit with UIFlow 1.3.2.
When I place "read user with id access" block(as below), I cannot save the sketch.
Please let me know how to solve this problem.....
Thanks... I will try to use OLED by Arduino IDE.
Can I use M5Stick's OLED screen with UI.Flow?
I set port A for CatEar, it is OK!!
I'd like to set CatEar with UIFlow of M5Stick, how do I set Port?
Is there a way to use the default FW somewhere?