Hello everyone. I purchased the atom motion https://docs.m5stack.com/en/atom/atom_motion. I d like to know if I could control servos each ones independently or only simultaneously with i2c protocol supported in atom motion. Is it possible to access each channel? There are examples with micropython?
Posts made by thop
atom motion control servos independently or simultaneously, access each channel
Timer Camera X do not work
I uploaded the code to camera timer X. This result appeared at the end
Sketch uses 2100483 bytes (66%) of program storage space. Maximum is 3145728 bytes.
Global variables use 53560 bytes (16%) of dynamic memory, leaving 274120 bytes for local variables. Maximum is 327680 bytes.
I suppose it worked. The only change I had made was to include my network information (I used the Arduino IDE and code provided in the m5stack support). I can't see anything with the camera. I put the ip on an ip camera app, but it didn't work