Hi @thrasher ,
Maybe one day we will open source. :)

Best posts made by IAMLIUBO
-
RE: UIFlow 1.7.5
Hi @anvalin ,
Sorry about that, since the M031-C module firmware version is relatively low, some AT commands do not match the AT user manual, so they are not supported yet. -
RE: UIFlow for C3
Hi @all,
Like @Dario said, current UIFlow FW based on micropython v1.12, so only support esp32, not support esp32-xx, but we are working on it, UIFlow 2.0 will support STAMP-C3 or others chip.
Have a nice day.
IAMLIUBO -
RE: How to control m5stickc pins via uiflow?
Hi @robalstona ,
In fact, G36 can only be used as input, I think you should remember it wrong. -
RE: How to control m5stickc pins via uiflow?
Hi @d3f4u1t ,
I just test it and it work well.
pin G26 still have 3V even I already set it "digital write pin G26 value 0"
Are you measuring the result with a multimeter?
-
RE: More than one of the same units on an I2C-Bus?
Hi @Peter ,
For us, the I2C address of most units is fixed so that you can use it directly. If you want to use multiple units with duplicate addresses, it is recommended that you use PAHUB, which can provide up to 5 I2C devices with the same address. Into. If you want to use multiple PAHUBs at the same time, you may need to change the position of some resistors. However, UIFlow does not currently support the selection of PAHUB addresses. We may update them in a future version.
-
RE: Blynk in UIFlow
Hi @ksprayberry @inasawa ,
Sorry for that.The bug should be resolved, it was our fault, please try again and sorry again. -
RE: UIFlow 1.7.3
@titimoby
This is not something I can decide, but we will wait until that day :) (Maybe soon -
RE: UIFlow 1.7.4
Setting high voltage allows the screen to keep the content displayed after the power is off, without fading.
-
RE: UIFlow 1.7.5
@anvalin It's possible.But I did't test, I will let you know,if I test it.
-
RE: [UiFlow] The ability to display multiple "screens" or "cards"
Hi @DaveC ,
I understand your thoughts. This feature is indeed very practical. We are also investigating how to implement it. It may not be launched soon. I think we will launch this feature at the right time.
The main problem at present is that we may need to unify the GUI framework of all devices.
This may take a long time. -
RE: LOVE THE CORE2!!! - Possible bug in UIFlow Desktop - Compiler code order - Function buttons stop responding
Hi @mbunds
Thanks for feedback and sorry for this,actually the UIFlow desktop version not updated for a while,we are aim for web UIFlow current, and plan release the new UIFlow(we call it UIFlow 2.0).
-
RE: M5Paper / Touch only working on USB power
Hi @all,
Hi, sorry for taking so long to reply.Next version(v1.9.2) will jugement the address after power on.