Best posts made by gordsh

@SadE54 I believe it is.

Hi Teastain, thanks for your response. We will try and create a model in Fusion 360 using the physical dimensions. Thanks for your help.

Does anyone know the correct pin assignment for the M5Dial SPI bus? I am trying to run LVGL with TFT_eSPI. I have tried the pin assignments I obtained from the M5Dial specifications page but I am having no luck. Here is what I have so far

// For ESP32 Dev board (only tested with GC9A01 display)
// The hardware SPI can be mapped to any pins

#define TFT_MOSI 5 // In some display driver board, it might be written as "SDA" and so on.
#define TFT_SCLK 6
#define TFT_CS 7 // Chip select control pin
#define TFT_DC 4 // Data Command control pin
#define TFT_RST 8 // Reset pin (could connect to Arduino RESET pin)
#define TFT_BL 9 // LED back-light

Hello, we are using the M5 Dial in a project to build a touch screen controller for an aircraft and need it to complete the modeling in Fusion 360 of the electronic and hardware design

@gordsh thanks for sending, I actually don't know eez studio at all, I have never used it..

@PharkieB Here you go

M5Dial v6.f3d

@PharkieB Here is one that I made a while back M5Dial.stl