@ajb2k3 Are you using the M5 libraries and MP 1.19? if so, how did you manage to use that MP version with M5
fbritop
@fbritop
Posts made by fbritop
-
RE: New MicroPython version
-
RE: New MicroPython version
@ajb2k3 Great!, what MP version are you targeting?
-
New MicroPython version
When could we have an updated version of micropython on the burner?
Current version points to 1.12, from 1.13 up we can use uasyncio V3, which is very important for async requestsv1.12 comes is now more than 2 years old
-
MQTT Can't create threat
Has someone has this issue, after it connects to the mqtt broker, it crashes with a message "Can't Create Threat". I have tried several servers, including my own with aedes
Core2/MicroPython
-
ESPNOW and wifiCfg
I have a Core2 which connects to internet as a Station.
Also I'm using espnow to connect to nearby ESP01 relays.I cannot figure out how to enable ESPNOW as AP, and Wifi connection for internet throught a router as a STATION.
If I config the STATION, when I configure next he ESPNOW, Wifi STATION disconnects. If I connect first (init) the ESPNOW, then the WiFi STATION, ESPNOW does not work.
I know that ESP can work at the same time as an AP and STA, but here I cannot figure out how to do both at the same time with MicroPython
Here I connect to my Wifi
Here I init the ESPNOW
I cannot figure how to run both modes at the same time, which I´m sure ESP32 is capable
-
RE: ESP-Now UIFlow to Arduino
@xio1996 I was trying to do the same thing. I have some ESP01 relay controlers, which they work fine between them aand an ESP32 WROOM. I'm now trying to use a Core2 as a master, but I haven't been able to communicate with the ESP01.
Do you have any example codes for Core5 in MicroPython?
Thanks in advance
FBP -
Core2 as AP and Station
Can the Core2 under MicroPython work at the same time as an Access Point and as a Station?
I know ESP32 can do it (I have done it with MongooseOS), but I'm not sure about MicroPython.Thanks
-
Universal IOT Experiment Kit SHT30
With the Universal IOT Experiment Kit for ESP32(SHT30). Can the core be switched to an Core2 or is not compatible?
Thanks
-
RF433 TX and UIFlow
Is there any chance that the RF433 TX could bne included in the UI Flow?
I could not find it in the units (Core2 controller)
Thanks in advance