Lcd driver for M5Stack Core2
Russ last edited by
@wolli01 At the very end of the program before it quits.
This post is deleted!
I have a problem with the SD card.
My program runs sometimes 1-2 days well through and then when it comes to an error and hangs, it is restarted by the watchdog. When restarting but then no longer the SD card with the command:
sd_device = sdcard.SDCard(spi, cs=Pin(4), baudrate=20000000)
Do you have a tip what this could be and how I can change it?
when I install the new firmware 1.16, I get the message that the build rate is unknown.
If I go back to 1.14, everything runs without problems.
Do you know what the problem could be?
ajb2k3 last edited by
Is the SD card being filled ?
Yes works perfectly at the beginning.
Sometimes many days without problems and then is no longer written to the SD card.
Sometimes it no longer works after a few hours.
Is there a way to disable the Core2 in software?