Finger Unit with UIFlow
I am trying to use Finger Unit with UIFlow 1.3.2.
When I place "read user with id access" block(as below), I cannot save the sketch.
Please let me know how to solve this problem.....
Hi @tomorrow56 please update to version 1.3.5 and retry
I cannot switch the version of UIFlow to 1.3.5...
"1.3.5" means the firmware version?
Now the website was updated to 1.4.0, try upgrading your firmware to 1.4.0 and try again. Sorry I don't have a finger unit to test now.
Still I cannot switch UIFlow to 1.4.0...
I can only switch to 1.4.0-bata or 1.3.2.
And even if I open it on the 1.4.0-beta site, I can't save this sketch.
Save menu is not working, the Run button does not respond.
Thank you and best regards,
I use the Web IDE version.