M5Stack with a moisture sensore, Arduino IDE

[kat]

Hello,
I need to work with the module M5stack core kit V1.0 . I try to connect a moisture Funduino sensor to this module with a Arduino IDE but i cann't do it...
Before i have try with the sensor DHT11 and i can receive the temperature, but with the moisture sensor i don't find anything. I connected:

• to the GND

• to 3,3 V
  S to GPIO22


The sensor use a analogic output, you know where i need to connected the data pin about the sensor in the CORE kit?

Thank you very much for your help.

[ajb2k3]

@kat said in M5Stack with a moisture sensore, Arduino IDE:

Hello,
I need to work with the module M5stack core kit V1.0 . I try to connect a moisture Funduino sensor to this module with a Arduino IDE but i cann't do it...
Before i have try with the sensor DHT11 and i can receive the temperature, but with the moisture sensor i don't find anything. I connected:

• to the GND

• to 3,3 V
  S to GPIO22


The sensor use a analogic output, you know where i need to connected the data pin about the sensor in the CORE kit?

Thank you very much for your help.

Sorry you picture hasn't worked.

• to 5V

• to GND
  s to 35 or 36 on the black I/O base
  
  then something like the following to read the pin.

int analogPin = G35; // potentiometer wiper (middle terminal) connected to analog pin g35
                    // outside leads to ground and +5V
int val = 0;  // variable to store the value read

void setup() {
  Serial.begin(9600);           //  setup serial
}

void loop() {
  val = analogRead(analogPin);  // read the input pin
  Serial.println(val);          // debug value
} 

May I ask what you are planning to use the sensor for?

[kat]

ok nice thank you for your help !

I have connected the sensor to th pin 26 and it work.
i want to know the humidity in the earth for my plants.

[kat]

It' show this for example:
moisture: 0
moisture: 125
moisture: 658
moisture: 1254

What i need to put in the program to have just one line with " moisture values : " and the values changes every 1seconds?
Like a clock

[ajb2k3]

@kat @Rop you need to create and M5ez project, create a text place holder and set the code to replace the text with the values. Hopefully @Rop will pick up the notification and help you out. My knowledge is more towards Uiflow