UIFlow 1.7.6

ajb2k3

Hello @shally1986

same here. I think the reason for the green light blinking is that when M5Stack (Gray) is turned off it doesn't fully turn of the 5 V. (I measure about 2 V when turned off.)

That said, I think GoPlus2 was designed for M5Stack (Gray, Fire, etc.) and not for M5Core2 since w/o electrical modification you'll loose external I2C on M5Core2.

Thanks
Felix

Am I missing something here, the GoPlus2 was designed for the core2's (hence the 2 designation) the Goplus was designed for the core/gray/go/fire.

I haven't had time to check the Goplus2 as its connected to a robot and been busy with other projects.

felmue

Hello @ajb2k3

I don't know for sure for which core the GoPlus2 was designed for, but I think it was meant for M5Stack (Gray, Fire, etc.).

All I can say (looking at the schematic) is that electrically it is not fully compatible with the M5Core2.

Also, all Arduino examples I can find are for M5Stack (Gray, Fire, etc.) and none for M5Core2.

And the GoPlus (first generation) is EOL.

BTW: I don't think the '2' is because it is meant for M5Core2. It's simply the successor of the first GoPlus module. Which, if I am correct, is an unlucky (and confusing) naming.

Thanks
Felix

ajb2k3

@felmue I took it that it was for the core 2 as it has the different case shape and the longer Mbus header pins

m5stack

@doswiadczalnik now it fixed. you could remove the old firmware file then download again.

ajb2k3

8Servos hat intermittent response with 1.7.6

OyczE

@m5stack when we gonna see UiFlow with zigbee Init and COM ?

m5stack

@ajb2k3 could you share your code here? it would helpful for us to debug it.

m5stack

@mati It is in our support plan and will be supported in future updates. so maybe after a few weeks, it will be supported.

OyczE

@m5stack thx, maybe some day uiflow will be able to support new HW at rls day ;)

plusulli

I cannot get a QRCODE for the Cloud with the UNITCAM examples.

kmart93179

I use weight unit for port A and the GOPlus2 Base at the same time. it seem like it cant work together,When i trigger the server motor ,my weight unit dont work anymore,the label keep show 0 ,i think maybe is I2C issue ,any ideas?
thx
skyler

kmart93179

?????????

m5stack

@kmart93179 weight unit is not used the I2C protocol of course they not compatible.