Topics created by scroggyg

I did a check and set scaling to 1 and the display is properly shown i.e. as 9:59 etc

@scroggyg Hi, the SIT3088 is a "converter" from UART to RS-485. To write/read the RS-485, use the UART1 (TX:20, RX:21).
The setup below works, although I have to store the arrays first somehow, before setting them into my text box (top_box), as the text appears briefly and then disappears ...but I can see I am receiving OK.
I got the tab5 yesterday ...and RS-485 was the first thing I wanted to test it.
35754316-24e0-4e02-9011-94aae5b44237-image.png

You would need to strap the board to do this. I created a board and getting it made at JLCPCB. The CANPwr board is quite expensive, reasonably enough, it is electrically isolated.

Hello @scroggyg

in UIFlow2 under Hardware you can find the Watch Dog Timer (WDT) module.

I created a example in the UIFlow2 Project Zone: M5Tough_Watchdog_Test_UIFlow2.2.8

Thanks
Felix

@JKarriot