@ajb2k3
Hi thank your for your answer. Yes I read the m5stackwebsite, google, youtube... but not many things about the M5 tough, or how to get started. I understood quickly I needed to do a firmware flash to uiflow2, but that doesn't seem to work for some reason. If you can point me to some usefull info I would certainly appreciate this.
I think find and bind will only work if I get the UIflow2 firmware working ?

@felmue
Hi, yes you are correct, I already suspected something like this.But I can't figure out why UIFlow is not running.
When I look in the M5 burner, and I search for "Tough" I do find "tough_tools" and the display currently looks exactly like this.(as you mentioned).

I can also find UIFlow_Tough, this is for the V1 uiflow I suppose.
For the UIFlow2.0 I can find "Uiflow2.0 (core2/tough/Core2 v1.1).
Here I select V2.0.5-Tough. Then Download.
Then Configure -> COM4, I add the wifi settings, and time zone.
I select : show startup menu and network setup
Powermode : USB IN BUSOUT
Then Next -> It says Burning

.

Detecting chip type...
ESP32
Chip is ESP32-D0WDQ6-V3 (revision v3.1)
Features: WiFi, BT, Dual Core, 240MHz, VRef calibration in efuse, Coding Scheme None
Crystal is 40MHz
MAC: 08:f9:e0:d2:66:f4
Uploading stub...
Running stub...
Stub running...
Changing baud rate to 1500000
Changed.
Configuring flash size...
Auto-detected Flash size: 16MB
Flash will be erased from 0x00009000 to 0x0000efff...
Compressed 24576 bytes to 503...
Writing at 0x00009000... (100 %)
Wrote 24576 bytes (503 compressed) at 0x00009000 in 0.3 seconds (effective 663.5 kbit/s)...
Hash of data verified.

Leaving...
Hard resetting via RTS pin...
"Burn Sucessfully"

Did a long press on the side button to turn it off, turn it back on via the button.
Turned off the power by removing the usb cable and put it back in.

And then.....everything stays the same on the device ?
What am I missing ?

Hi,
I just bought my first m5 tough (first m5 device every), so everything is new to me.
Installed the driver : ok (device connected on COM4)
Could write the firmware to UIflow2.0 (2.0.5-Tough) with M5 burner (logged in to my account).

I can't get write any program to the device via web uiflow2. It's possible to connect, but when writing a program a just hangs.
Also the device is not bound to my account.
On the M5 tough device itself, I am seeing "Tough Tools" and serveral menu-items on the bottom of the screen wirfi, touch, I2C,etc...)
Searched for many hours , but documentation is not very basic and unclear. Getting frustrated...not a fluent start...
Who can help me ?