I had the same problem.
Core2 did not turn on after 1.7.1.1
Currently I am using 1.7.0 instead.

I keep finding this thread whenever I search using ENV II over PaHUB, so instead of openning a new one I wanted to continue on this.

I am new to development boards however I am an experienced platform developer.

I have a Core2 and I want to use PaHUB and add couple of more units to read. I have no problem reading data via using Wire command over PaHUB like using 4way Relay.

However, I have no idea how to use BMP and SHT over PaHUB. I have tried combining examples without any luck and tried above without any luck.

Question is after portselect, how come bmp access to right address? If you can point me to any direcon, I will be grateful.

Cheers.