Posts made by M5Joe

I have the same issue. Sensor runs with easyloader example. Did anybody solved it? Could it be, that pins are not assigned correctly with uiflow? there is a matching table on the docu web page, where pins should be assigned according the controller you use. But how can I change pin assignment in a uiflow example?

Are there any news according Servo support?
I still do not find any way of support (Pin servo or module).
It's been over an year now and should be an easy task to support it in UiFlow.
Did anybody find a solution to control 180° / 360° servos with UiFlow 2?

Hi
Can anybody give me a hint, how to flash / load on the GRBL Module 13.2 Stepmotor Driver?

• which hardware do I use to flash with Arduino IDE?
• where do I find the firmware GRBL 0.8 for M5Stack module (i2c version)?
• how do I have to flash it e.g. which board do I have to chose?

furthermore
Did anybody upgrade the module to GRBL V1.1?
Can I just use the common Arduino Uno version?

Thanks for your help.