Control Stepper Motor with Core2 and GRBL 13.2
-
Hello,
I'm using the Core2 controller and the GRBL 13.2 module. I want to drive two stepper motors continually at a slow speed. The motors are attached to rollers, so they should be continuously rolling.The motor I purchased is a Nema 17 bipolar from here: https://www.ebay.com.au/itm/175580114720
I have the motor turning using the example Arduino code, but the torque is very low; we can twist the axel easily.
What could be causing the toque to be so low? Have I specced the motor incorrectly, or do I need a different driver?
Thanks -
Could be alsorts like incorrect supply voltage, incorrect setting on the module or issues with the code.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login