ESP-NOW appears to be NOT working on V2.4.0 and V2.4.1 Firmware?
-
Environment: UIFLOW2
Device: M5Dial V1.0 (not the newer V1.1 with the RTC)
Problem: communication between a Core2 and M5Dial using ESP-NOW with:
Version 2.4.0 and 2.4.1 of the Firmware to be used with UIFLOW2Greetings all,
It appears that at least on the M5Dial V1.0 that the ESP-NOW is not working (just seems dead) until I move to down to V2.3.9 of the firmware (which brings up other problems with formatting which I did find a solution to rid the b').
I think this issue MIGHT exist on the CORE2 but I ran out of time to verify because of a problem I created.
Any thoughts on a fix /workaround or I am the only one using the ESP-NOW?
Thanks-Brian
PS: TAB5 does not have ESP-NOW listed in UIFLOW2 which I would be a better suited solution.
Project Overview for the curious: using multiple M5Dials that are connected to a ENVIII for air temperature monitoring and a DS18B20 for floor temperature monitoring in each of the seven zones on the first floor of the house which is using radiant floor heating. The M5Dials will communicate using ESP-NOW to a CORE2 which is acting as a "base". When the temperatures falls below the set temperature the CORE2 will using a EXT I/O 2 to control a relay board with in turn will control the values that allow hot water to flow to each zone on the first floor of the house.
