M5StickC Plus2 Stopped Connecting
-
I have been using M5Burner and the Arduino IDE to download demos into the M5StickC Plus2 -- all was fine and then I started getting this message.
A fatal error occurred: Failed to connect to Espressif device: Wrong boot mode detected (0xb)! The chip needs to be in download mode.
I fails to download anything at any baud from M5Burner or the Arduino IDE. Did my stick go bad? I just received it about a week ago.
-
Have you tried putting the stick into download mode?
-
@ajb2k3 how to do it?
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login