Hi guys

I tested M5Tab5 (running UIFlow 2.3.1) with all the units I have available and most of them worked ok.

Note: I also got the i2c driver install error, but it didn't cause I2C to actually fail.

GPIO units

SSR - ok

I2C units (bus speed 100k)

Env III - ok Env IV - ok ExtIO2 - ok Color LCD - ok OLED - ok PaHUB - Env IV - ok

I2C units (bus speed 400k)

PbHUB - ok 4Relay - ok

Unit Gesture and AMeter did not work for me with either bus speed 100k or 400k. M5Tab5 seemed to hang in setup and a hard reset was required.

Thanks
Felix