My M5stick doesnt work, after i instaled unofficial marauder!

severopotter

I can run burn normally, but my screen simply won't turn on, the LEDs also work!

The firmware
0_1705633844394_b54ad406-09f0-4ca8-bc14-ff079a8d58b1-image.png

ajb2k3

@severopotter that’s for the plus2.
You need to erase and re burn UIFlow.
It’s not the device broken, it the version uses a different hardware configuration

severopotter

@ajb2k3

But, my device is the plus2
0_1705662900360_57697821-1f85-497b-87fe-1ea0f51dc216-image.png

i've tried erase:
0_1705663281650_ad776f60-0d59-4e54-a1d7-03ae33550761-image.png

and burn again
0_1705663408905_0059b5d5-e131-4363-beaf-439153516abd-image.png

firmware monitor:
0_1705663482361_9f8e7f26-1d70-40a5-ba71-8db06ffccfed-image.png

and it still doesn't work :(

ajb2k3

You didn’t say that earlier.
Erase the firmware and install arduino or UIFlow firmware and avoid

severopotter

@ajb2k3 but I'm not doing that in the images above?

severopotter

@ajb2k3 i've tried

#include "M5StickCPlus2.h"

void setup() {
auto cfg = M5.config();
StickCP2.begin(cfg);
StickCP2.Display.setRotation(1);
StickCP2.Display.setTextColor(RED);
StickCP2.Display.setTextDatum(middle_center);
StickCP2.Display.setTextFont(&fonts::Orbitron_Light_24);
StickCP2.Display.setTextSize(1);
StickCP2.Display.drawString("Power LED", StickCP2.Display.width() / 2,
StickCP2.Display.height() / 2);
}

void loop() {
// inside power red led control
StickCP2.Power.setLed(1);
delay(1000);
StickCP2.Power.setLed(0);
delay(1000);
}

in arduino, but the display didn't work