Sharing Code for RC Servo tester
-
Hi.
I just start code m5stack for 2 day (My model is m5stack fire).
This code support 3 mode .-
Manual Mode. You can set RC servo from 0 to 180 degree.(10 degree per step.)
-
Center Mode. This mode will lock servo at 90 degree.
-
Sweep Mode. This mode will loop sweeping servo to 0, 90 and 180 degree then sweep back to 90 and 0 degree.
-
-
Well, that’s a bit more interesting then my attempt at a servo tester. Thank you for sharing. Do you mind if I add it to the UIFLOW handbook?
-
Very cool, could i add it in uiflow example
-
@pattiuak said in Sharing Code for RC Servo tester:
Hi.
I just start code m5stack for 2 day (My model is m5stack fire).
This code support 3 mode .-
Manual Mode. You can set RC servo from 0 to 180 degree.(10 degree per step.)
-
Center Mode. This mode will lock servo at 90 degree.
-
Sweep Mode. This mode will loop sweeping servo to 0, 90 and 180 degree then sweep back to 90 and 0 degree.
Ahh, wrong port was set, now working on the Black Core.
-
-
@ajb2k3 I don't mind. Please do it.
-
@heybin Please do it.
-
@pattiuak said in Sharing Code for RC Servo tester:
@ajb2k3 I don't mind. Please do it.
Thank you Very Much!
