Let's get started with the #M5Stack #M5GO #IOT Starter KIT. https://www.hackster.io/AJB2K3/m5go-iot-starter-kit-part-1-8ef6ae
ajb2k3
@ajb2k3
I tried to fill this in but easily distr........
Ouuu Squirrel!
Posts made by ajb2k3
-
How to get started with the M5GO IOT Starter KIT
-
RE: SensorHub
@idefixcert As long as devices have different address (and sufficient power) up to 200 devices can connect to the I2C bus (I think)
-
RE: [Documentation] AtomS3 Schematics
@saiyande I would hazard a guess that its because the same PCBis used for the AtomS3 and the AtomS3lite version.
-
RE: M5card computer
Have you charged it?
-
RE: 質問:AirQの振る舞いについて
@m5uiflowhamuzui00 said in 質問:AirQの振る舞いについて:
M5Stackを数か月前から始めた初心者です。
黄砂がきになり、思い切ってAirQを購入いたしました。
取説を見ながら設定を進め、スマホとつながり測定値を読むことまではできました。
次に、USB給電を行うと画面が乱れ、動作も遅くなる現象が生じました。USBを外すと画面の乱れは直ります。
試しに M5 Burner を用いて AirQ の AirQ-UserDemo V.0.1.1 を書き込んだところ、USB給電時の画面の乱れは解消しましたが、以下の気になる点が生じました。
・VOCとNOxのデータが取得できていなさそう
・AirQ本体の時間表示がGMT +9 に変更されない
購入時のプログラムとV0.1.1の差など、AirQ に関しての情報をお持ちの方がいらっしゃいましたら、ご教授を賜れましたら幸いです。
どうぞよろしくお願いいたします。画面の乱れは正常に動作するようになっています。
タイムゾーンはファームウェアにハードコーディングされます。 -
RE: New Core2 not turning on
Use M5Burner to erase the firmware and burn UIFLOW2 for Core2/Core2AWS.
once the process is complete and the button turn green, close M5Burner and press the reset button. -
RE: Powering Core 2 using battery connector?
The Best way is to connect the power through the MBUS in the underside
-
RE: My M5DINMeter is not working.
Press reset on the din.
Did you burn the correct version of iiflow2 and did you erase first -
RE: Compatibility with the Stepmotor driver module 13.2 v1.1
Sometimes the module does connect properly so make sure the module is secure to the core without the base. If still not working check the MBus pins for the two devices match.